Instruction manual

92 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 3 — Software Installation
10. Select the IP address for the Network card that will communicate with
the Jupiter system. This is the IP address that you were asked to obtain
earlier.
Note Consult with your Network administrator if you do not know the network
values to enter.
• If there is more than one Network card installed, all the cards will
appear in the dialog window. Select the preferred network card.
• Enter the Port information in the respective fields
11. Enter the IP address for the Controller boards in the required field and
then click the
Next> button.
Using DHCP Warning
Note It is strongly recommended that you use a Static IP address. Using DHCP
may cause configuration problems.
If you are using DHCP, that is your IP address is not static, you will see
the following Question dialog (Figure53).
Figure 53. Question Dialog
This dialog is a warning; however, a Static IP address must be entered to
avoid operation problems.
If you want to enter a Static IP address, click the Ye
s button, stop the instal-
lation process and then add the static IP address after restarting the Instal-
lation.
If you do not want to correct the IP address, click the
No button.