Owners Manual
13
RJ-45 DB9
Pin-1 = DSR Pin-1 = N/C
Pin-2 = DTR Pin-2 = RXD
Pin-3 = CTS Pin-3 = TXD
Pin-4 = GND Pin-4 = DTR
Pin-5 = RXD Pin-5 = GND
Pin-6 = TXD Pin-6 = DSR
Pin-7 = N/C Pin-7 = N/C
Pin-8 = Power Input Pin-8 = CTS
Pin-9 = Power Input
Remarks: e Cat 5 cable that plugs into this adaptor and then into the
rear panel RJ-45 port must use pin-to-pin wiring (pin one to pin one, two
to two and so on).
9 USB Port
e USB connector is used to host a USB stick for updating amplier
rmware, should that become necessary.
10 Ethernet Port
e Ethernet port allows control and update features when connected to a
local network. It supports DHCP (dynamic host conguration protocol)
which means that it will have an IP address automatically assigned. If static
IP addressing is required, it can be accomplished by creating a reservation
table (see your router’s settings page) based on the amplier’s MAC address
printed on its serial number label (back-panel).
To perform rmware updates via the Ethernet port a network connection,
web browser and the rmware le (*.bwu extension) is all that’s required.
In order to access the amplier’s web interface, the assigned IP address
needs to be entered in the browser’s address bar. Locate the IP address by
looking at the connected devices table in your router’s setup interface,
or by using a network scanner app from a mobile device on the same
network. If a reservation for the amp has been assigned in the router’s
settings, then it will be the reserved IP address. Once the web page is
loaded, please follow the instructions shown in the “Firmware” tab.