Owners Manual
32
You do not need to have all or even any lters enabled for every channel. e
installer need only make the adjustments to the channels necessary to correct
for the room’s interaction. We encourage you to consult with your authorized Classé
dealer to properly calibrate the Parametric EQ function.
NOTE: a discrete IR command or Fkey may be used to toggle the
EQ on and o to easily compare before and after from the listening
position. When the EQ is enabled, EQ appears on the Home page.
Tone Control Setup e Tone Control may be congured as conventional bass and treble controls
or used as what is sometimes called a tilt control. In either conguration, the
maximum boost and cut is 6.0 dB.
e default setting congures the Tone Control as a Tilt control with low- and
high-frequency 3 dB points at 200 Hz and 2,000 Hz respectively. ese values
are user adjustable, allowing customization of the frequency ranges manipulated
by the tilt control. e Tilt control will adjust frequencies above and below
these inection points by tilting the tonal balance in one direction or the
other, stepping the higher frequency range up or down in 0.5 dB steps while
simultaneously stepping the lower frequency range in the opposite direction,
down or up, leaving the frequencies in between unchanged.
If conventional bass and treble controls are desired, select that option and
choose the frequencies below which the bass control works and above which
the treble control works. e bass and treble controls may be accessed from the
touchscreen (Menu> Tone Control) or by pressing Tone on the remote. Use
the navigation buttons on the remote or the touchscreen buttons to increase
or decrease the level of bass and treble independently. e Tone Control is
activated and deactivated by successive pressing of the TONE button on the
remote control, choosing the tone control icon on the Classé app, or selecting
and deselecting the Enable box on the touchscreen. e app makes using the
Tone Control particularly easy, allowing quick selection of Tilt, Bass/Treble and
None while using its virtual volume control knob to adjust levels.
DC Triggers e Delta PRE has two available trigger controls. Each may be programmed
using normal 12 V or “inverse logic” (0 V) settings. e ability to change the
way the trigger operates can solve installation-specic problems that otherwise
require external devices that add to both the cost and complexity of your system.
e triggers can be associated with the Standby mode, a specic source or a
conguration. To use the Inverse Logic option, simply check the Inverse Logic
box on the Trigger Setup page.
For more information on the potential use of DC triggers, we recommend you
speak with your authorized Classé dealer.