Specifications

C2985M-A (3/11) 5
Installation
1. Locate the camera’s USB accessory port.
2. Connect the accessory appropriate for one of the following camera types:
• IE Series and Spectra HD Series: Connect the accessory directly to the camera’s USB
accessory port.
NOTE: For Spectra HD Series cameras, the ALM-1 alarm accessory must be connected to the
accessory port closest to the dome drive when installed (refer to Figure 1).
• IX Series and ID Series: Connect the mini USB cable (supplied) to the accessory, and then
connect it to the camera’s USB accessory port.
• IM Series: Connect the left-angle USB cable (supplied) to the accessory, and then connect it
to the camera’s USB accessory port.
Figure 1. Installing the AUD-1 and ALM-1 into a Spectra HD Series Camera
3. Connect the appropriate wiring (refer to Wiring on page 6).
4. Log on to the host camera, and enable the camera’s audio or alarm streams as needed. Refer to the
installation/operation manual shipped with the camera for complete instructions.
NOTE: Improper use of audio/visual recording equipment may subject you to civil and criminal penalties.
Applicable laws regarding the use of such capabilities vary between jurisdictions and may require, among
other things, express written consent from the recorded subjects. You are solely responsible for insuring
strict compliance with such laws and for strict adherence to any/all rights of privacy and personalty.
ì=
Spectra HD Dome Drive Receiver (located inside the back box)
î=
USB Ports
ï
AUD-1 Audio Accessory
ñ
ALM-1 Alarm Accessory
ó=
Spectra HD Dome Drive