OWNER’S MANUAL Omega SACD2
CONTENTS Safety Precautions 3 Thank You From Everyone At Classé 3 Classé Design Philosophy Single Circuit Design Listening: The Critical Design Element Extended Real-World Lifespan Our Pride in Manufacturing, Your Pride in Ownership 3 3 3 3 Introduction Congratulations How to use this manual 4 4 4 Unpacking and Positioning Contents Installing batteries in the remote control Positioning the Omega SACD2 Player 4 4 4 4 Connections AC power Digital outputs Analog outputs Infrared (IR) input and output
SAFETY PRECAUTIONS WARNING: failure to comply with these safety instructions can cause serious injury or death, or cause your Classé Omega SACD2 Player to be severely damaged or destroyed. Do not operate the Classé Omega SACD2 Player with any portion of the chassis removed or open. Dangerous voltages and laser radiation may be encountered. Connecting this unit to AC voltages other than that specified on the rear of the unit may cause extensive damage and increase risk of shock.
INTRODUCTION UNPACKING AND POSITIONING Congratulations Congratulations on your new purchase. From all of us at Classé, we hope you enjoy many years of musical satisfaction from your new Classé Omega SACD2 Player. Unpack your Omega SACD2 Player carefully. If you notice any shipping damage, contact your dealer immediately. Saving the packaging material is advised in case the unit needs to be shipped for service.
CONNECTIONS Pictured below is the rear of the Omega SACD2 showing all input and output connections. AC power Check that the AC voltage for which this unit is configured matches your local AC line voltage. The correct operating voltage is indicated on the rear of the power supply chassis, adjacent to the AC power inlet. Operating this unit on AC voltage other than that specified on the rear of the unit can damage or destroy this unit and increase the risk of electric shock.
CONTROLS AND OPERATION This section describes all of the controls, front panel display, and operation of the Omega SACD2 Player. Turning on AC power The Omega SACD2 is turned on by means of a power switch located on the rear of the unit. Do not turn the AC power on until all connections have been made. Standby mode If the Omega SACD2 Player is left idle for more than five minutes, it will automatically enter Standby mode.
Front panel display Below is an illustration of the Omega SACD2 front panel display and a description of each indicator. The remote control The remote control provides access to all functions available on the front panel. In addition, several functions can only be accessed from the remote control. For instructions on how to use keys that are duplicated on the front panel, see the instructions in the previous section. For other functions, see complete descriptions in the relevant sections of this manual.
Loading or unloading a disc To load a disc, follow these steps: 1. Press the LOAD key on the front panel to open the drawer. 2. Once the drawer is open, place the disc (with the label facing up) on the drawer. 3. Press the LOAD, PLAY, or SKIP keys to close the drawer. To unload a disc, press LOAD. Playing a disc After the disc is loaded and the drawer closed, the Omega SACD2 Player will begin to detect which type of disc has been loaded.
Controlling the display The Omega SACD2 Player display function can be changed using keys on the remote control as follows: ON/OFF Pressing the ON/OFF key will cause the display to toggle between ON mode and OFF mode. In OFF mode, the display will remain off until a key on the front panel or the remote control is pressed. In ON mode, the display remains illuminated during operation. TIME The TIME key changes how the front panel display indicates time.
Using the Omega SACD2 remote control with other Classé products The Omega SACD2 Player remote control can be used to control all Omega pre-amplifiers. VOLUME UP/DOWN Pressing these keys will raise or lower the preamplifier or integrated amplifier volume level. MUTE Pressing MUTE will cause the pre-amplifier or amplifier output to mute. Pressing either VOLUME UP or DOWN will cause the unit to un-mute. See the owner’s manual for your Classé product for more detailed information.
WARRANTY AND SERVICE For warranty service, contact your Classé dealer or Classé Audio directly at: Classé Audio 5070 Francois-Cusson Lachine, Québec Canada H8T 1B3 Telephone: Fax: email: Website: +1 514 636 6384 +1 514 636 1428 cservice@classeaudio.com www.classeaudio.com V1.