Owner`s manual

24
Connect the FL & FR Outputs, either RCA or XLR, from the rear panel of
the SSP to the corresponding inputs on your amplier(s). Connect Center,
Surround Left and Surround Right channels to the corresponding inputs on
your amplier(s).
• Ifyouareusingasubwoofer,connecttheSSPsubwooferoutputto
the input of the designated amplier or powered subwoofer.
NOTE: Make sure connections from the subwoofer output go only to an
amplier connected to a subwoofer or a powered subwoofer, as low frequency
signals can damage a small speaker not designed for high output bass
reproduction.
When connecting a cable, make sure the cable has a good connection and is
rmly attached to the rear panel connectors on both the amplier and the
SSP.
e Sigma SSP also provides two Auxiliary analog audio outputs. See the
section on Conguration Setup for more details about the Auxiliary outputs. If
used, connect the AUX output(s) to its corresponding amplier(s).
Step 5 Connect the loudspeakers to the amplifiers.
Important! Verify that the power amplifier(s) is plugged in but powered
OFF before connecting to the SSP.
Connect each loudspeaker to its designated amplier channel. Pay close
attention to the phase of the speaker connections – always connect an amplier’s
red (+) terminals to the red (+) terminals of the loudspeaker. Likewise, connect black
(–) terminals to black (–) terminals.
Step 6 Power up the system!
NowyouarereadytopowerupyourSigmaSSPandyouraudiosystem.
• TurntherearpanelpowerswitchoftheSSPtoON. e Standby
LED will turn red.
• PressthestandbybuttoncontainingtheLED. e initial power-up
cycle of the SSP only takes a few seconds.
• Whenthepower-upcycleiscomplete,theSSPentersOperatemode
and the touchscreen becomes active.
• PresstheStandby button to toggle the SSP into and out of Standby.
e physical setup of the Sigma SSP and system components is complete.