Owner`s manual

31
Using the Sigma SSP
eSigmaSSP’sversatiletouchscreenLCDsupportsyourday-to-dayoperations
and provides access to a exible menu system for controls and setup functions
thataren’taccessedasoften.issectionoftheowner’smanualoutlinestheuse
of the touchscreen in routine operation of the system.
When you bring the SSP out of Standby mode, the touchscreen displays the
Home page, as shown below.
e Home page displays the volume in large font which is easily visible from
across a room. e selected source appears at the bottom of the screen. At the
bottom center of the screen the format of the incoming signal is displayed.
is displays the sampling frequency of digital sources as well as the le format
(ALAC,WAV,FLAC,etc.)ofstreamingNetworksourcesorBypassifsoselected
for analog sources. If Pass-ru is selected for either digital or analog sources, the
volume display will read 0.0 and be greyed out (since the volume control is not
active in this mode). is page can be quickly accessed at any time by pressing
the Home icon on the touchscreen display.
Source Selection TouchingthescreenwhenontheHomepagebringsuptheSourceSelection
page. e number of source buttons appearing here corresponds to the number
of inputs that have been set up and are “enabled.” A maximum of nine sources
may appear on one page. If more are enabled, they will be available on the next
page by touching the button in the upper right corner of the page. See
the section on source setup in the Menu System. e Sigma SSP has up to 18
selectable source buttons which are all interchangeable.