Owner`s manual

The Menu System

e comprehensive menu system provides setup and conguration controls for

the Sigma SSP. ese installation-specic features let you customize how the SSP

works within the context of your particular system. Changes are made on-the-y,

which allows you to quickly set up and modify settings without constantly being

askedifyou’resureyouwanttomakethechangeandpressingentertosave.e

SSP stores settings in non-volatile memory whenever it is put into standby, so

it’sagoodpracticetoputtheunitintostandbyaftermakingchanges.Innormal

daily operation this happens anyway, but if you want to be sure a loss of power

doesn’teraseyourchanges,puttingtheSSPintostandbywillgiveyouextra

assurance.

Pressing the Menu button on the front panel (or if an Fkey on the remote

control has been programmed to perform the Menu command) will open the

main Menu page, which is divided into six sections as shown below.

At the top right of the menu pages you may nd a button which uses the

arrow icon when additional menu options are available, and/or a Home button

for returning to the Home page. When on the main Menu page, pressing the

Menu button returns to the Home page. If you are on a page within the Menu

System, pressing the Menu button returns you to the main Menu page. When

you navigate beyond the main Menu page a return or back button using the

icon appears on the upper left corner of the page. is returns you to the

previous page.

System Setup TouchingtheSystem Setup button on the main Menu page opens the System

Setup page, which contains ten setup options, the rst nine of which are shown

below,withTeachIRlocatedonthenextpage.