Owner`s manual

34
From the System Setup menu, you can:
• tailoryourinputstoyourparticularsourcecomponents
• congurethesystemtotakebestadvantageofyourloudspeakers
• tailorthedisplaytoyourpreferences
• setvolumecontrolparameters
• enable and setup the Parametric EQ
• setupToneControlparameters
• viewtheunit’sNetworkIPaddress/statusandsettings
• choose Remote F key functions
• teach IR commands
Source Setup Each of the 18 source buttons supported by your Sigma SSP can be customized
in several ways to enhance system performance or to simplify operation. e
source select page is dynamic in that it shows up to nine sources on a single page.
If six or fewer are enabled, then the page shows six somewhat larger buttons
and if three or fewer are enabled, it shows only three large buttons. Press the
button for the source you want to set up. e setup page for that source includes
buttons for assigning the input connector(s) and naming the source, choosing
a default speaker conguration, setting an input oset, selecting the Pass-ru
feature or choosing the Digital Bypass path.
Enable Source is check box activates/deactivates source buttons. If the Enable Source box is
checked,thenthesourceisenabled.IftheEnableSourceboxisNOTchecked,
then the source is considered not enabled and is so identied on the Source
Selection page.
Disabling unused sources is a good way to simplify source selection. e
Source Selection page is dynamic, adjusting the number and size of buttons to
correspond to the number that are actually being used or enabled. e buttons
arrange themselves into groups of either three, six or nine buttons on the Source
Selection page.
Input Connector Choose the input connector(s) to be associated with this source button. Any
source button may be associated with any input connector(s). Also, multiple
source buttons may be assigned to the same connector(s).