Owner`s manual

Configuration Setup e Conguration Setup page allows you to dene up to six dierent speaker

congurations.Touchthebuttonforthespeciccongurationyouwanttoset

up to open its conguration setup menu. e page contains buttons for naming

the conguration and enabling balanced (XLR) and single-ended (RCA) outputs

for Front L&R, and independently enabling Center, Subwoofer, Surround and

Auxiliary outputs. Choosing a subwoofer output causes a Bass Management

button to appear. e same menu is used to set up each conguration.

Configuration Name Aswithnamingsources,presstheCongurationNamebuttontoaccessthe

keyboard used for customizing the conguration name. Press Enter after making

your changes to save the new name.

Configure Outputs Choose the output connectors you want enabled with this conguration. If

a subwoofer is used, a Bass Management button appears, allowing you to set

crossover frequency and slope.

If you also want to High-Pass Filter any of the main output channels, check the

box for HP Filter corresponding to the speaker group for which you want the

HP lter setting to apply. e crossover will pass the higher frequencies and

correctly direct the low frequencies to the subwoofer(s) based on your frequency

andslopesettings.Ifthisboxisunchecked,thecorrespondingchannels’signals

will pass full range.