Owner`s manual

43
Youdonotneedtohaveallorevenanyltersenabledforeverychannel.e
installer need only make the adjustments to the channels necessary to correct
fortheroom’sinteraction.We encourage you to consult with your authorized Classé
dealer to properly calibrate the Parametric EQ function.
NOTE: a discrete IR command or Fkey may be used to toggle the
EQ on and o to easily compare before and after from the listening
position. When the EQ is enabled, EQ appears on the Home page.
Tone Control Setup eToneControlmaybeconguredasconventionalbassandtreblecontrols
or used as what is sometimes called a tilt control. In either conguration the
maximum boost and cut is 6.0 dB.
edefaultsettingcongurestheToneControlasatiltcontrolwithlow-and
high-frequency 3 dB points at 200 Hz and 2,000 Hz respectively. ese values
are user adjustable, allowing customization of the frequency ranges manipulated
by the tilt control. e tilt control will adjust frequencies above and below
these inection points by tilting the tonal balance in one direction or the
other, stepping the higher frequency range up or down in 0.5 dB steps while
simultaneously stepping the lower frequency range in the opposite direction,
down or up, leaving the frequencies in between unchanged.
If conventional bass and treble controls are desired, select that option and
choose the frequencies below which the bass control works and above which
the treble control works. e bass and treble controls may be accessed from
thetouchscreen(Menu>ToneControl)orbyassigningtheTonecommand
to one of the F keys on the remote. Use the navigation buttons on the remote
or the touchscreen buttons to increase or decrease the level of bass and treble
independently.eToneControlisactivatedanddeactivatedbysuccessively
issuingtheTonecommandviaIRwitharemotecontrolorselectingand
deselecting the Enable box on the touchscreen.