Owner`s manual

Network Setup eNetworkSetuppagedisplaystheIPaddressoftheSigmaSSPandthe

Networkstatus.

PressingtheRestoreNetworkDefaultsbuttononthispagere-enablesDHCP

mode. In DHCP mode the SSP obtains an IP address from a device on the

Network(usuallytheWirelessAP).

UKECversionunitsareshippedwiththeWakeonLANfeaturedisabled.When

in standby, they will not respond to commands from control interfaces via the

NetworksuchasCANBus,RS-232,IPControlandtheClasséApp.Contact

your dealer to determine the best means of bringing your SSP out of standby. In

most cases, this can be done using automation options that make the function

seamless and transparent.

e Sigma SSP includes a built-in web interface that can be used to congure

thesystemname,NetworksettingsorupdatetheSSPsoftware.Toaccessthe

interface,typetheIPaddressdisplayedontheNetworkSetuppageinthe

URL line of your browser (e.g. 192.168.1.0) and hit return. Alternately if you

are using Safari on the Mac, you can “Show All Bookmarks” (See: Bookmarks

menu) and click on Bonjour and double click on your Sigma SSP device listed

intheWebpage’sfolder.

Onthewebpage:StatusInformationwillshowtheSystemNameandthe

Firmware Version number.

Conguration will allow you to personalize the system name and congure the

unit’sIPaddressmanually.ItisstronglyrecommendedtouseDHCPratherthan

attempttoassignastaticIPaddress,butifoneisrequired,anITprofessional

should be involved in the installation.

Firmware Update

via Network

AsanalternativetothestandardUSBstickmethodofupdatingtheunit’s

rmware, updates may be initiated from the Sigma SSP web interface page. First

go to the Software Downloads area of the Classé website and download the latest

rmwarelocatedintheSigmaSSPUpdateviaLANfolder.UsingtheFirmware

tab on the SSP web page, conrm that the rmware version currently installed

is not the latest and click on the System restart button. Follow the prompts to

complete the update.