Owner`s manual

51
features CAN-Buswillallowa Class é touchscreen to:
• Displaystatusinformationforeveryconnectedunit,includingampliers
which do not have a touchscreen display.
• Createa“PlayLink”thatallowsanSSPorPreamptoautomaticallyswitch
to the correct input when a Delta series source component starts playback.
• Adjusttheglobalsystembrightness.
• Conguretheentiresystemtogoinandoutofstandbyatthetouchofa
button and also bring individual components in and out of standby.*
• Muteanyconnectedunit.
hardware setup 1 Classé CAN-Bus Equipped Products
TwoormoreClasséCAN-Busequippedproductsarerequired,atleastoneof
which must have a touchscreen display.
2 Category 5 Network Cables
ese are ordinary network cables, commonly used for broadband Internet
connections. ey should be typical “straight through” cables not the “crossed
over” type, and the total required will be one less than the total number of
CAN-Busequippedcomponentsinyoursystem.
3 CAN-Bus Terminator
AsingleCAN-BusTerminatormayberequired.Itisinsertedintothe
CAN-BusOUTconnectorofthelastcomponentintheCAN-Bus
daisy chain. One is includedintheaccesoriesbox.T hey are also available
free of charge from your nearest Classé Customer Support Centre.
http://www.Classeaudio.com/support/service.htm
4 SSP-300 & 600 CAN-Bus Interface Box
Systems that include an SSP-600 or SSP-300 will also require an
SSP-300/600CAN-BusInterfaceBox.eseareincludedwiththeproductsor
available free of charge from your nearest Classé Customer Support Centre.
http://www.Classeaudio.com/support/service.htm
* UKEC version Sigma series units require alternate means of being
brought out of standby.