Owner`s manual

59
3 One speaker or subwoofer seems not to be playing.
P If the problem occurs with all inputs, check the interconnecting
cables between the preamp and the power amp. Also check the
speaker wires for secure connections.
PCheckthebalancecontrolsettingbypressingMENUonthe
front panel, and then verify the balance control setting is not
turningonechanneloorreducingit’soutput.
P If the problem occurs for a subwoofer, make sure it is enabled on
the conguration assigned to this source button.
P Check the interconnect cables between the source component
and the SSP.
4 The IR remote control does not seem to function.
P If this is the rst time you are using the remote, check to see
that the protective lm has been removed from the battery. (See
Using the Remote and Accessing the Battery).
P Ensure that there are no obstacles between the IR remote and the
IR sensor, located on the lower left corner of the front panel.
P Check the orientation and if necessary, replace the batteries in
the remote control.
5 There is a hum coming out of the speakers.
P If the noise is coming from channels using single-ended
interconnects, make sure they are not placed alongside any
ACpowerorcommunicationscablessuchasCANBus.Also
make sure that they are not too long – long single-ended
interconnecting cables have a natural tendency to pick up noise
even when shielded.
PIfanysourcecomponentsareconnectedtocableTV,try
disconnecting the cable television line from the source
component. If the hum goes away, you need an isolation device
betweenyourcableTVconverterandthesourcecomponent.
YourClassédealercanhelpyouobtainoneoftheseinexpensive
devices.
network/streaming
troubleshooting
1 The Network Status page shows Not Connected and there are
no green and amber lights illuminated on the Ethernet cable
connector on the rear panel.
PCheckthattheEthernetcableisconnectedtoanactiveNetwork.
PTrysubstitutingtheEthernetcabletoconrmwhetherthecable
itself is functioning.
P If using a wireless bridge, make sure it is connected to your
wirelessNetworkandthatyouareusingthecorrectconnector
(labeled <...> on an Airport Express).
2 The Network status indicates Connected but the SSP does not
appear on your list of devices in AirPlay or on your DLNA
Media Player.
P Restart all participating components one at a time until the
problem is resolved. First the Media Player, then the SSP (cycle
the power o and on) and then your router. If the problem
persists verify that you have a valid IP address. If your address
is “Limited Auto IP” then the SSP has auto assigned itself an
address and this indicates that your DHCP IP address server is
not working.