Owner`s manual

Changing the Trim affects all modes and all inputs identically.

You may increase or decrease the level of any given channel

by 8 dB. Since the intent of “Trim” is to modify the output for

an individual movie or piece of music, the effect is not

permanent. When the “Standby” mode is selected, or the

ON/OF Switch on the rear panel is used to turn the unit fully

off, “Trim” memory is erased. Permanent changes to the

individual channel levels can made in “Setup” in as

discussed in Section 5.

7) MENU

This button selects the Setup menu. It calls up the first Main

(Configuration) MENU display, even if a lower level menu is

currently displayed EXCEPT when the Main MENU is already

displayed. In this case, pressing MENU will exit the menu

system entirely. For a full explanation of its operation and

importance see Section 5. Day to day use of the SSP-25

should not require use of the “MENU” button.

8) MODE

functionally identical to the front panel Mode control (Front

Panel, #8, above) steps through the SSP-25’s operating

modes in the following sequence: DTS, Stereo Surround,

Stereo, Mono Front, Mono Center, Dolby Digital®, and Dolby

Pro Logic®.

9) UP “/\” (Up Arrow)

Increases settings selected in the setup sequence. Also used

to increase channel level in the “Trim” mode.

10) LEFT “<” (Left Arrow)

Selects the previous (Configuration) MENU items. Also used

to move back through the channels in “Trim” mode

11) ENTER

The “ENTER” button, and the associated directional buttons

arrayed around it, are used to navigate through the setup

sequences which become available when the “MENU” button

is pressed. See Section 5 for full explanation of their use.

12) RIGHT “>” (Right Arrow)

This button selects a subsequent (Configuration) MENU item.

Also used to move forward through the channels in “Trim”

mode.

13) DOWN “\/” (Down Arrow)

Decreases settings selected in the setup sequence. Also

used to decrease channel level in the “Trim” mode.