Owner`s manual

55
7.5 First Aid
The SSP-25 control circuitry is based on the most advanced microprocessors available today. As is often the
case with personal computers, the SSP-25 might occasionally exhibit some anomalies. With computers, most
of these difficulties result from AC line surges, sags or outages, spurious inputs, etc.
The SSP-25 functions in an even harsher environment as it will be connected to cable and satellite video
sources that provide even more direct pathways for unwanted electrical or electronic interference.
If you experience unexpected behavior, or if the SSP-25 “locks up” and does not respond to control
commands, simply reset it by turning the rear panel On/Off switch Off. Wait about 10 seconds and then turn it
On again. This resets all the internal control circuitry and will undoubtedly solve almost all the problems you
experience. You may need to actually unplug the unit from the wall or remove the AC cord from the rear of the
unit for 15 or 20 seconds to get it to “unlock”.