Brochure

ManualsBrandsClasse ManualsAmplifiersClasse Delta Mono Power Amplifier

DELTA

™

SERIES

Summary of content (7 pages)

PAGE 1
D E LTA ™ S E RI ES
PAGE 2
“ There has to be s o m e t h i n g b e t t e r. ” These were the words of Mike Viglas in 1979, sending The DR-2 was introduced in 1980. It was a 25W stereo him on a path to the founding of Classé Audio. amplifier operating in class A, widely recognized as the Mike was passionate about many things, especially music. He loved showing off his latest Hi-Fi system at parties. Then, the inevitable happened. BOOM! Lights flickered, and silence.
PAGE 3
THE NEW DELTA ™ SERIES Try. Evaluate. Improve. Always be open to something new. Relentlessly attack anything that could compromise the purest possible signal path. Strip away all unnecessary complexity. Eliminate everything in the way of the shortest, cleanest path possible. We use class A circuitry, the purest form of amplification. Circuit boards are hand-laid, using six independent layers to optimally isolate signals, power and ground planes.
PAGE 4
DELTA PRE PRE AMPLIFIER The Delta™ PRE is a powerful and comprehensive control center that helps you get the most from every source and each recording in any room. Every source, from Phono to Network, finds a short, direct signal path through this preamp/DAC. Analog and digital sources alike are rendered in exquisite detail, with vivid tonal colors and lifelike dynamics. Features including 0.
PAGE 5
DELTA MONO POWER AMPLIFIER Class A is widely recognized as the purest form of amplification, where both sides of the amp track the entire signal, thereby eliminating the crossover distortion inherent in class B and A/B designs. Delta™ series amplifiers capitalize on class A throughout the critical range of power delivery. The Delta MONO delivers 35W in class A and 300W overall. For low-impedance loads, the amplifier will develop over 1,000W @ 2Ω. The Delta STEREO, built to the same standard, delivers 12.
PAGE 6
Input Impedance (at 1kHz, BAL / SE) 50kΩ Output Impedance BAL / SE 200Ω / 50Ω Maximum Output Level BAL / SE 18Vrms / 9Vrms BYPASS MODE Power (nominal input, 0dB 540mW/Ch Output Impedance 6.8Ω gain, 32Ω load) FILE FORMATS AND SAMPLE RATES SUPPORTED USB-F 44.1k, 48k, 88.2k, 96k (iOS specific) USB-B 32k, 44.1k, 48k, 88.2k, 96k, 176.4k, 192k, 352.