Owner's Manual

18
using CAN-Bus CAN-Bus is controlled via the touchscreen of any
Classé component that is
so equipped. ere is no master component, so
Classé series systems where
two or more units have a touchscreen can be controlled through any of the
touchscreens. However, it is probably easiest to start using CAN-Bus through
just one.
CAN-Bus is accessed by pressing the menu button on the face of the unit or
remote, then the status button, followed by the more button (right arrow)
in the upper right corner of the screen. e touchscreen will then display the
CAN-Bus devices screen, which lists connected components by model & serial
number.
Selecting a unit on the CAN-Bus devices screen identies it as the target unit.
e front panel LED(s) or meter light of the target unit will start ashing (unless
you choose the unit that you are using to access CAN-Bus).
Once you have chosen the target unit, the touch screen will list the CAN-Bus
features available to it. Some CAN-Bus features are shared by all models, some
are specic to individual models.
Make sure to exit the CAN-Bus pages before putting your unit(s) into
Standby, otherwise the previously selected unit will continue to ash its
front panel LED when powering up the next time.
CAN-Bus amp features e following CAN-Bus features are available on the Delta MONO.
e model, name and rmware version number will be displayed on the
CAN-Bus page of the targeted unit.
Operate e Operate button allows you to bring the target unit in and out of standby.
is button will be disabled for the unit whose touchscreen you are using to
access CAN-Bus.
Mute Engaging Mute will mute the output of the target unit.