Owner's Manual
8
Caution! If you see the Standby LED indicator blinking red, please
check that all external connections are cleanly made
and secure. If no fault is immediately obvious, try to
reset the amplifier by pressing and holding the standby
button. If the unit does not reset or continues to enter
protection mode, please call your authorized Classé
dealer for assistance.
2 ICTunnel
™
Air Intake
e Intelligent Cooling Tunnel removes heat from the amplier by pulling
cool air through the intake on the front panel. To ensure the proper
operation of the cooling system, be careful to keep the area around the air
intake on the front panel free of obstructions.
3 Output VU Meter
e output meter shows output power in Watts into an 8 ohm load and
provides a good relative indication of output in dB. A good rule of thumb
is that when the pointer is below/left of vertical the amplier is operating
in class A.
e backlight of the VU meter may be adjusted to three dierent
brightness levels or turned o. To adjust the brightness level, with the
amplier in standby, press and hold the standby button for approximately
5 seconds. e backlight will begin cycling through its brightness levels.
When the desired brightness is reached, release the button.