Owner's Manual

Using the Delta PRE

e Delta PRE’s versatile touchscreen LCD supports your day-to-day operations

and provides access to a exible menu system for controls and setup functions

that aren’t accessed as often. is section of the owner’s manual outlines the use

of the touchscreen in routine operation of the system.

When you bring the Delta PRE out of Standby mode, the touchscreen displays

the Home page of the menu system, as shown below.

Home Page e Home page displays the volume in large font which is easily visible from

across a room. e selected source appears at the bottom-left of the screen. At

the bottom center of the screen the format of the incoming signal is displayed.

is displays the sampling frequency of digital sources as well as the le format

(ALAC, WAV, FLAC, etc.) of streaming Network sources or Bypass if so

selected for analog sources. If Pass-ru is selected for either digital or analog

sources, the volume display will read 0.00 and be greyed out (since the volume

control is not active in this mode).

ere are also indicators at the bottom-right of the screen.

• TONE indicates that the tone control feature is enabled

• EQ indicates that the Parametric EQ feature is enabled

• MONO indicates that the Delta PRE is running in mono mode

rather than stereo.

• e headphone icon indicates that there are headphones plugged in

and that the rear analog outputs are muted.

• e turntable icon indicates that the currently select source is set

for phono mode. Phono may have up to 63dB of gain compared to

non-phono sources.

is page can be quickly accessed at any time by pressing the Home button on

the remote control or tapping the home icon on the touchscreen display.

Source Selection Touching any part of the screen when on the Home page brings up the Source

Selection page. e number of source buttons appearing here corresponds to the

number of inputs that have been set up and are “enabled.” A maximum of nine

sources may appear on one page. If more are enabled, they will be available on

the next page by touching the

button in the upper right corner of the page.

See the section on source setup in the Menu System.