Replacement Part List

WARNING!
Do not operate the snow thrower with the cover on.
CAUTION!
Let your snow thrower cool before you put the cover on.
Installation
Check your snow thrower to make sure there are no sharp objects or corners that
could stress your cover as you pull it on.
Starting at the handlebars, slip your cover over the top of your snow thrower, with the
underside hem "FRONT" label on the front of the thrower, then pull the cover down
on all corners. You may need to adjust control levers to get a good fit.
Use and Storage
Your Snow Thrower Cover has an integrated storage bag. To fit your cover in the bag
fold and roll it tightly rather than stuffing it. Never store a wet cover in the storage
bag or confined area as the cover can be damaged by mildew.
Cleaning and Care
Clean your cover with a soft brush and luke-warm water. DO NOT USE SOAP as it may
remove the protective coatings added by the factory. Air dry.
Instructions: Snow Thrower Cover
do not iron
do not
pack wet
do not
use soap or
detergent
line dry
no bleach
water
resistant
no tools
required
52-067-010405-00, 52-003-040105-00
15cH56_18839
CLASSIC ACCESSORIES, INC., KENT, WA USA 98032
©2015 classicaccessories.com