Instructions / Assembly

WARNING!
Installation is best done with two people
and on most RVs requires working from the
roof of the RV. Never install on a windy day
or when the RV roof is slippery. Please take
care when you are on a ladder or the roof.
CAUTION
Installation and removal is safer and easier
when done by two people. Please consult
your RV owners manual.
Tools Needed:
• Scissors
• Matchesorlighter(optional)
• Screwdriver(usuallyPhillipshead)for 
roof antennas
Installation
1. Cover or tape any sharp edges on your RV
thatcouldwearagainstyourRVcover.Be
sure to lower any roof antennas.
2.OnsmallerRVsyourcovercanbe
installed with ladders but on most RVs it’s
easiesttoinstallyourcoverfromtheroof.
Carefullyclimbupontheroofandhavea
friendhandyouthecoverinitsstoragebag.
AtthefrontofyourRVcarefullyremoveyour
coverfromitsstoragebag.WiththeClassic
logotothefrontofyourRV(Thecover
shouldbepackedsothatthefrontisatthe
outsideoftheroll)unrollthecoverdown
the length of the roof. Drop the front of your
coveroverthefrontofyourRVthencarefully
andslowlymovetowardthebackoryour
RVspreadingoutyourcoverandlettingthe
sides fall down the sides of your RV.
 Climbdowntherearladderandlocatethe
laddercap.(Thecaphelpskeepthetopof
theladderfromstressingthecover).Fitit
overtheladdertopandattachittotherungs
with the hook and loop straps. Now pull the
backendofthecoverdownthebackofyour
RV.
3.Zipallthepanelsclosedonyourcover
thenpulltheelasticizedcornersdownover
both bumpers of your RV.
4. Tieanendofthe
supplied rope onto
one of the D-rings
along the bottom
hem.Putasmall
rockintheprovided
tossbag,closethe
top and tie the free
end of the rope to
thebagD-ring.Toss
the bag and rope
under your RV to
the D-ring on the
oppositeside.Take
the rope off the bag
and,allowingenoughtomakeaknot,cutit
off and tie it to the D-ring. Repeat with the
remaining D-rings.
 Tokeeptheropeendsfromfrayingyou
cancarefullymelttheendswithamatchor
lighter.
5. Adjust the strap length on the white
tensionpanelsacrossthefrontandbackto
fit your RV. Don’t over tighten—the straps
shouldbesnug,notdrumtight.Toattach
thestrapsintotheside-releasebucklesjust
inserttheclipintothebuckle.Toreleasethe
bucklepressthebuttonsonbothsidesand
pulltheclipoutofthebuckle.
Use and Storage
Thesidesofyourcovercanbeunzipped
foraccesstothedoors,engineorstorage
areas.Thepanelscanberolledupand
heldinplacewiththehookandloopstraps
towardthetopofeachpanel.
Ahandystoragebagisprovided.Tofitit
inthebagfoldyourcoverandrollthecover
tightly rather than stuffing it. Never store
awetcoverinthestoragebagorconfined
areaasthecovercanbedamagedby
mildew.
Care
Spotcleanwithwater,amildsoapanda
sponge.Don’tuseabrasivecleanersor
brushes.
70263, 70363, 70463, 70563, 70663, 70763, 70863
ExtraTallModels:77563, 77663, 77763, 77863
Instructions: PolyPro3
™
Deluxe Class A RV Cover
12cR55_12856
do not
pack wet
do not iron
line dry
water
resistant
do not
use soap
CLASSICACCESSORIES,INC.
KENT,WAUSA98032 ©2012
classicaccessories.com