Product Manual

WARNING
THIS IS A STORAGE COVER ONLY. Do not use while
transporting your snowmobile — the cover could blow
off and cause injury to others.
1. Cover any sharp points (such as a windshield corner)
with cloth or a sponge to avoid stressing your cover
when it is stretched tight across your snowmobile.
2. Find the white label with arrows sewn in the hem of
the cover–this is the front of your cover. Now stretch
the cover down over your snowmobile.
3. Locate the strap [A] in the middle of your cover
(Fig. 1). From where the strap attaches to the cover,
run the strap end with the male buckle under your
snowmobile and then back up to clip it into the female
buckle. Tighten the strap so that is snug, but not
cinched completely tight.
4. Run the forward strap [B] under your snowmobile
behind the ski struts and connect it into the buckle on
the opposite side.
5. Run the rear strap [C] under the tail of your
snowmobile into the buckle on the opposite side.
Tighten all the straps as necessary for a tight fit on
your snowmobile.
CLEANING
Clean your cover with a soft brush and some lukewarm
water. It may also be machine washed in COLD water.
DO NOT USE SOAP, as it may remove the protective
coatings added by the factory. Line dry or machine dry
on air or delicate.
STORAGE
A handy storage sack is attached to the rear of your
cover. Be sure the cover is completely dry before you
store it in the sack for an extended period.
SNOWMOBILE STORAGE COVER
Figure 1
A
C
B
14cOS55_16861
71527, 71537, 71547, 71557, 71537-WC, 71547-WC
CL
ASSIC ACCESSORIES, INC.
2264
0 68th AVENUE SOUTH
KENT
, WA USA 98032 ©
2014
cl
assicaccessories.com