Instructions / Assembly

INSTRUCTIONS

Installation:

1. Look for the label sewn into the bottom hem of your enclosure that says “Back”. Drape

your enclosure over your golf cart with the label in the back.

2. On the underside of each corner of your enclosure you will find two

webbing straps. One of the webbing straps has a buckle attached to it.

Run the long webbing strap around your car’s windshield support pillar

then through the buckle on the opposite strap (Fig. 1) and tighten.

Repeat on the remaining three corners.

3. Zip the zippers down from the outside of your car on each of the

four corners.

4. On each side, along the bottom of the cover, there are three hooked

straps for securing your cover to the bottom of your golf cart. Hook the straps under your

cart at the front corner, back corner and in the middle by the door, then adjust the tension

with the buckle on each strap.

5. Unzip the doors on the sides to enter your golf cart. To keep the doors open simply roll

the door up and fasten with the straps at the top.

(Tip: If you want to get in and out of your cart without rolling up the door just unzip the

middle zipper. You will be able to enter or exit by pulling the door back toward the front of

the car.)

6. Gear can be loaded and unloaded at the back by unzipping the two rear zippers.

7. In good weather, the front panel, doors, back side panels, and back panel can be rolled

up independently.

Storage

Your Enclosure comes with a handy storage bag. DO NOT STORE YOUR COVER FOR

LONG PERIODS WHEN WET - your cover could mildew. When storing your cover on your

golf car make sure to roll down all of the panels.

TIP: If the clear vinyl windows on your cover are wrinkled from storage you can smooth

them out with a hair dryer - just take care not to melt the window.

Cleaning

Clean your cover with warm water and a SOFT cloth. DO NOT USE SOAP OR ANYTHING

ABRASIVE WHEN CLEANING THE VINYL as it scratches easily.

The camouflage fabric may be cleaned with soap and water but again, do not use anything

abrasive.

3 Year Limited Warranty

Your Enclosure is factory warranted for defects in workmanship and materials for 3 years

after purchase. Trailering you golf cart with this cover

on it will invalidate your warranty.

Made by

Classic Accessories, Inc., Kent WA 98032

72076 (pg. 2 of 2) 08.27.07

PAGE 1
INSTRUCTIONS Installation: 1. Look for the label sewn into the bottom hem of your enclosure that says “Back”. Drape your enclosure over your golf cart with the label in the back. 2. On the underside of each corner of your enclosure you will find two webbing straps. One of the webbing straps has a buckle attached to it. Run the long webbing strap around your car’s windshield support pillar then through the buckle on the opposite strap (Fig. 1) and tighten. Repeat on the remaining three corners. 3.