Product Manual
Instructions: Deluxe Travel Trailer Cover
WARNING!
Installation is best done with two
people. Never install on a windy day
or when your trailer roof is slippery.
Please take care when you are on a
ladder or the roof.
CAUTION
Please consult your RV owners
manual.
Tools Needed:
Scissors
Matches or lighter (optional)
Screwdriver (usually Phillips head) for
roof antennas
Installation
1. Cover or tape any sharp edges on
your trailer that could wear against
your cover. Be sure to lower any roof
antennas.
2. Unroll the cover next to your trailer.
The Classic logo on your cover should
be to the front of your RV and facing
the outside. Unzip the passenger side
and back panels.
3. On smaller trailers your cover can
be installed with ladders or by pulling
it over the sides with tie ropes. (Be
sure not to snag the cover on the top).
On larger trailers it’s easiest to
install your cover from the roof.
Carefully climb up on the roof pulling
the cover front with you. Lower the
front of your cover down over the front
of your trailer then carefully move
toward the back pulling the cover and
letting it fall down the sides of your
trailer.
Climb down the rear ladder and
locate the ladder cap. (The cap helps
keep the top of the ladder from
stressing the cover). Fit it over the
ladder top and attach it to the rungs
with the hook and loop straps. Now
pull the back end of the cover down
the back of the trailer.
4. Zip all the panels closed on your
cover then pull the elasticized corners
down over both bumpers of the trailer.
5. Tie an end of the supplied rope
onto one of the D-rings along the
bottom hem. Put a small rock in the
provided toss bag, close the top and
tie the free end of the rope to the bag
D-ring. Now toss the bag and rope
under your trailer to the D-ring on the
opposite side. Take the rope off the
bag and, allowing enough to make a
knot, cut it off and tie it to the D-ring.
Repeat with the remaining D-rings.
To keep the rope ends from fraying
you can carefully melt the ends with a
match or lighter.
6. Adjust the strap length on the
white tension panels across the front
and back to fit your trailer. Don’t
over tighten—the straps should be
snug, not drum tight. To attach the
straps into the side-release buckles
just insert the clip into the buckle. To
release the buckle press the buttons
on both sides and pull the clip out of
the buckle.
Use and Storage
Your cover can be unzipped for access
to the passenger side and rear. The
panels can be rolled up and held in
place with the hook and loop straps
toward the top of each panel.
A handy storage bag is provided. To
fit it in the bag fold your cover and roll
the cover tightly rather than stuffing
it. Never store a wet cover in the
storage bag or confined area
as the cover can be damaged
by mildew.
Care
Spot clean with water, a mild soap
and a sponge. Don’t use abrasive
cleaners or brushes.
Three Year Limited
Warranty
If this cover fails due to a defect in
workmanship and materials within
three years from the date of purchase
Classic Accessories will repair or
replace it free of charge.
Trailering or towing your trailer
with your cover on will invalidate the
warranty
This warranty gives you specific
rights and you may also have other
rights which vary from state to state.
08cR55 _10352
73163 73263 73363 73463 73563 73663 73763 73863