Product Manual

Instructions: 5th Wheel Cover
WARNING!
Installation is best done with two
people. Never install on a windy day or
when your 5th wheel roof is slippery.
Please take care whenever you are on a
ladder or the roof.
CAUTION
Please consult your RV owners
manual.
Tools Needed:
Scissors
Matches or lighter (optional)
Screwdriver (usually Phillips head) for
roof antennas
Installation
1. Cover or tape any sharp edges on
your 5th wheel that could wear against
your cover. Be sure to lower any roof
antennas.
2. Unroll the cover next to your 5th
wheel with the Classic logo on your
cover at the front of your 5th wheel and
facing the outside. Unzip the side and
rear panels.
3. On larger 5th wheels it’s easiest to
install your cover from the roof. Care-
fully climb up on the roof pulling the
cover front with you. Lower the front of
your cover down over the front of your
5th wheel then carefully move toward
the back pulling the cover and letting it
fall down the sides of your 5th wheel.
Climb down the rear ladder and locate
the ladder cap. (The cap helps keep
the top of the ladder from stressing
the cover). Fit it over the ladder top
and attach it to the rungs with the
hook and loop straps. Now pull the
back end of the cover down the back
of the 5th wheel.
4. Zip all the panels closed on your
cover and then pull the elasticized
corners down over both bumpers of
your 5th wheel.
5. Locate the hook
and loop straps on
the upper part of
the flaps that fold
in under the nose
of your 5th wheel.
Adjust them to fit
your cover to the
exact length of the
nose of your 5th
wheel.
6. Once the length
of the nose of the
cover is correctly
adjusted, locate
one of the supplied ropes and the D-
rings sewn in along the flaps that fold
in under the nose of your 5th wheel.
Tighten the rope and tie it off onto the
D-rings located opposite each other.
Repeat with the lower D-ring.
7. Tie an end of the supplied rope onto
one of the D-rings along the bottom
hem. Put a small rock in the provided
toss bag, close the top and tie the free
end of the rope to the bag D-ring. Now
toss the bag and rope under your 5th
wheel to the D-ring on the opposite
side. Take the rope off the bag and,
allowing enough to make a knot, cut it
off and tie it to the D-ring. Repeat with
the other D-rings. To keep the rope
ends from fraying you can carefully
melt the ends with a match or lighter.
8. Adjust the strap length on the
white tension panels across the front
and back to fit your 5th wheel. Don’t
over tighten—the straps should be
snug, not drum tight. To attach the
straps into the side-release buckles
just insert the clip into the buckle. To
release the buckle press the buttons
on both sides and pull the clip out of
the buckle.
Use and Storage
Your cover can be unzipped for access
to the passenger side and rear. The
panels can be rolled up and held in
place with the hook and loop straps
toward the top of each panel.
A handy storage bag is provided. To
fit it in the bag fold your cover and roll
the cover tightly rather than stuffing it.
Never store a wet cover in the storage
bag or confined area as the cover can
be damaged by mildew.
Care
Spot clean with water, a mild soap and
a sponge. Don’t use abrasive cleaners
or brushes.
Three Year Limited Warranty
If this cover fails due to a defect in
workmanship and materials within
three years from the date of purchase
Classic Accessories will repair or re-
place it free of charge.
Trailering or towing your 5th wheel
with your cover on will invalidate the
warranty.
This warranty gives you specific
rights and you may also have other
rights which vary from state to state.
08cR55_10351
75263 75363 75463 75563 75663 75763
Extra Tall Modles: 75863, 75963, 75063