Product Manual
and-grip strips on the top and bottom of
the panels.
To avoid mildew do not store a wet
screen or privacy panels in an
confined area.
Care
Spot clean with water, a mild soap
and a sponge. Don’t use abrasive
cleaners or brushes, especially on the
privacy panels.
Warranty
If this product fails due to a defects in
workmanship and materials within two
years from the date of purchase Classic
Accessories will repair or replace it free
of charge. This warranty does not cover
damage caused by improper use or
installation of this product.
07cR59_010
WARNING
Use two people to install your Toy
Hauler Screen. When using a ladder
always take great care, especially if
using a ladder on the slanted door/
ramp to your Toy hauler.
CAUTION
For proper installation, we recommend
that you install the rip-and-grip tape
strips to your toy hauler. Make sure
that these DO NOT interfere with the
opening or closing mechanism of the
rear door of your toy hauler.
Caution
Be sure to read the instructions
BEFORE installing your Toy Hauler
Screen. Depending on your type of toy
hauler, the screen may be installed
on the outside or inside of the rear
door frame. You may prefer the look
of your screen when installed on the
outside but installation on the outside
of the frame will require removal of the
screen when closing your toy hauler
door. Not all toy hauler designs allow
installation to the inside of the frame.
Caution
High winds could cause the screen
to detach
.
Caution
It is best to let any installed rip-and-
grip adhesive tape cure for 24 hours
before use.
Materials needed:
• Ladder
Installation
Magnetic Version:
(For use with toy haulers with a steel
rear door frame.)
1. Measure the opening of the door to
find the center point and mark it in a
nonpermanent way (tape, soft pencil,
etc.).
2. Place a piece of rip-and-grip tape
(included) on each of the top corners
and the top center of the door frame.
3. Peel the adhesive backing paper off
the center rip-and-grip tape tab and
adhere it to the metal frame on the
centerline you marked in step 1.
4. Your screen is designed to fit
a variety of door widths by using
adjustable tabs at
the top corners to
shorten the width of
the screen. To adjust
the width, use the
tab to fold the top
edge of the screen
over and attach it
to the rip-and-grip
strip. Do the same
on the other side.
5. Working first on
one side and then
the other, adhere the
magnetic strips on the
edges of the screen to the
sides of the door opening.
6. Your screen is also designed to fit
two different door heights. To size your
screen to your door, find the rip-and-
grip adjustment strip sewn in near the
bottom of the screen. If your screen is
too long for your door opening, attach
the rip-and-grip strip on the bottom
of the screen to the strip sewn in just
above it.
7. There are magnets sewn in to
pockets at the bottom of your screen.
These will adhere to the bottom of the
door frame, keeping the screen closed.
Use and Storage
Your screen is equipped with privacy
panels that can be taken off if desired.
To remove, simply separate the rip-
Rip-and-grip width adjustment tab
on the top of the screen
Rip-and-grip strips on the bottom of the screen
Fold over and
attach to shorten
Instructions: Toy Hauler Screen
Magnetic Attachment Version
For use with toy haulers with a steel rear door frame
79994