Use and Care Manual

5. For all RVs
Included with your cover is a toss bag
to help you attach the straps under your
RV. Before you begin fill your toss bag
with rocks or something of equal weight
equivalent. Clip the toss bag to the buckle
strap attached to the tension panel (Fig
8). Now toss the bag under your RV to
the buckle on the opposite side (Fig 9).
Unclip the strap from the bag and buckle
the bag to the next strap. Repeat with the
remaining straps.
6. Adjust the strap length on the tension
panels across the front and back to fit
your RV. Don’t over tighten—the straps
should be snug, not drum tight.
The sides of your cover can be unzipped
for access to the doors. The panels can
be rolled up and held in place with the
rip-and-grip straps toward the top of each
panel.
Your cover is equipped with extra long
zipper pulls. To secure the zipper pulls so
that they do not drag on the ground bring
the ends of the zipper pulls up and tuck
them into the rip-and-grip closure located
at the base of the zipper along the hem
(Fig. 10).
Use and Storage
A handy storage bag is provided.
The bottom of your bag unzips and
expands to make packing easier.
Note: For easier packing and re-installing
fold and roll tightly before packing in
storage bag.
Never store a wet cover in the storage
bag or confined area as the cover can be
damaged by mildew.
Care
Spot clean with water, a mild soap and
a sponge. Don’t use abrasive cleaners
or brushes.
Fig. 10
Fig. 8
Fig. 9
do not
pack wet
do not iron
line dry
water
resistant
do not
use soap
18cR55_31128
CLASSIC ACCESSORIES, LLC
KENT, WA 98032, USA ©2018
classicaccessories.com
Instructions: PermaPRO
™