Use and Care Manual

NOTE: Some examples of potentially sharp
or abrasive points on your RV that you may
wish to cover with your SoftGuard™ foam
include, but are not limited to: gutters,
ladders, awnings, solar panels, antennas,
steps, slide outs and corners.
2. With another person lift the cover to
the roof.
3. Carefully climb up on the roof and take
your cover out of its storage bag (Fig. ).
Place the rolled-up cover at the front center
of the roof and unroll down the center of
the RV toward the back (Fig. ).
4a. Starting at the front, unfold your
cover from the center outwards. Continue
unfolding the cover as you work toward the
back, letting it fall over the sides of your RV
(Fig. ). Make sure the corners of the cover
are at the corners of your RV.
4b. For travel trailers and 5th wheels and
finish by zipping all the panels closed on
your cover then pull the elasticized corners
down over the bumper(s) of your RV.
5a. For Class C RVs
Your cover is equipped with triple zipper
pulls on the front side panels (Fig. ). These
extra zipper pulls allow the cover to fit RVs
with mirrors that do not fold against the RV.
Zip all three zipper pulls down to the mirror
height, then zip the bottom zipper to the
bottom of the cover. Create an opening at
the mirror height by zipping the top zipper
up slightly and the center zipper down
slightly. Slip the opening over the mirror and
close the top and bottom zippers around
the mirror post. Finish by zipping all the
panels closed on your cover then pull the
elasticized corners down over both bumpers
of your RV.
5b. For 5th Wheel RVs
Connect and loosely tighten the tension
panel strap across the bottom front of
the nose of your th wheel (Fig. ). Then
connect the rip-and-grip tabs that fold in on
either side just under the nose of your th
wheel (Fig. 6). Adjust and tighten straps as
necessary for a snug fit.
5c. For toy hauler RVs
If your Toy Hauler is a trailer type skip to
step . If your Toy Hauler is a th wheel
type, Unzip the second zipper from the
front up to the bottom of the overhang
on both sides. Buckle a strap to the upper
tension panel (Fig. ) (A) on the side of the
overhang and bring it across to the other
side and buckle. Repeat with the lower
tension panels (Fig. ) (B).
Fig. 
Fig. 
Fig. 
Fig. 
Fig. 
Fig. 
WARNING!
Cover for storage use only.
Do not occupy the RV while the cover
is on the RV.
Do not run the RV engine with the
cover on.
WARNING!
Do not use additional straps across
the top of the RV cover, as this could
possibly damage your vehicles roof
and/or the cover.
WARNING!
Installation is best done with two people
and on most RVs requires working from
the roof of the RV. Never install on a
windy day or when the roof is slippery
or wet. Please take care when you are
on a ladder or the roof. Be sure that
your helper does not pull the cover
while you are on top of the RV.
CAUTION
Installation and removal is safer and
easier when done by two people. Cover
or tape any sharp edges on your RV that
could wear against your RV cover. Be sure
to lower any roof antennas.
CAUTION
Ensure that your RV is clean before
installing the cover. Dirt or particles on
the RV could be rubbed by the cover in
windy conditions leading to wear and tear
on paint and/or finishes.
Tools
Some radio antennas may need to be
unscrewed; usually with a Phillips head
screwdriver. Your cover will fit over
flexible or flat antennas and AC units.
Installation
1. SoftGuard™ sharp edge protectors
Included with your cover are several foam
SoftGuard™ sharp edge protectors. They
can be used to cover sharp or abrasive
points on the vehicle and help prevent
the cover from ripping or tearing during
installation. To install the SoftGuard™
protectors place the open side of the
foam over the designated sharp or
abrasive point. Before putting the cover
on make sure to do a survey of your RV
for potential sharp or abrasive points and
install the SoftGuard™ foam protectors
where applicable.
Instructions: Encompass
™
cR_
CLASSIC ACCESSORIES, INC.
22640 68th AVENUE SOUTH
KENT, WA 98032, USA
©
2016
classicaccessories.com
CLASSIC ACCESSORIES, LLC
KENT
, WA 98032, USA ©
2019
classicaccessories.com