Owners manual

11
PARTS NEEDED TOOLS NEEDED
+
1
OPTIONAL 2a OPTIONAL 2b
2
ATTACH THE MOUNTING SYSTEM TO YOUR SNOW THROWER FRAME (FIG. 1-2)
Note: Exact positioning may vary depending on your machine.
Note: In some instances, it may be necessary to mount the loop clamps [L] or [M] above the handlebar crossbar support. This will help the
assembled shield sit higher for added protection.
Select either the small loop clamp [P] set or the large loop clamp [O] set and
check to see which clamp can slip onto the snowthrower handlebar uprights.
Note: You will only need one set of either [O] or [P] for this step. Use the part
that will provide the most secure fit when placed around the snowthrower
upright. If both [O] or [P] are loose follow the optional step shown below.
Select either the small loop clamp [P] set or the large loop clamp [O] set and
check to see which clamp can slip onto the snowthrower handlebar uprights.
Optional mounting:
Use supplied non-slip PVC [S] to cover side mounting bars.
Wrap material around side mounting bars.
NONE
STEP 5
O
O
O
S
O
P
S
R
Q