Owners manual

7
PARTS NEEDED TOOLS NEEDED
Insert the longer flexible rod into the slip pocket at the bottom of the shield shell.
Repeat with the shorter rod into the slip pocket at the top.
Make sure about 1 inch of the rod is showing.
3
1 2
ASSEMBLE THE FRONT SHIELD (FIG. 1-4)
WARNING: Use care when assembling the poles. Poles under tension can slip out of the metal/plastic sleeves causing serious

Insert one long hoop pole [I] into [J] to assemble the lower support rod.
Repeat with remaining short hoop poles [K] into [L], to make a separate
upper support rod.
Lay out the shield shell [H]. Locate the two small slip through
pockets on the inside of the shield fabric shell.
NONE
STEP 2
4
I J
I
 L
J
H
H