User manual

MIDI KEYBOARD CMK-2 INSTALLATION MANUAL v1.5
12 2009 CLASSIC ORGAN WORKS CMK-2 Manual 1.5.doc
First, note that the topmost keyboard should have the two shortest brackets. Then, sit the plastic supports on the end of
each keyboard (Figure 4) and fasten them in place with three #8 screws from underneath (Figure 5). Stack the
keyboards by sliding the slots on the upper supports over the pins on the lower supports. To slide the upper supports
into place, first tilt the keyboard up about 30 degrees. At that angle, the pins on the lower supports will slide through
the slots on the upper supports.
Figure 5: Install three #8 Screws in the Underside
Connectors
MIDI OUTMIDI OUT MIDI OUTMIDI IN
DC 12V INPUT 3 INPUT 2 INPUT 1
HEARTBEAT
LIGHT
+ O - + O - + O -
not used
Swell-shoe input for Ahlborn
Archive crescendo pedal
Standard swell-shoe input
parallel outputs (all the same)
GND
+12V
MIDI OUT
POWER
TERMINAL
BLOCK
ABBA
Figure 6: Rear View Connections