User manual

MIDI KEYBOARD CMK-2 HARDWARE CONFIGURATION MANUAL v1.5
CMK-2 Manual 1.5.doc 2009 CLASSIC ORGAN WORKS 23
Name Steps Function
7. SET A MIDI
CHANNEL TO
SEND VOLUME
MESSAGES
(CONTROLLER-7)
Hold the first piston from the left (SET) and
momentarily press the sixth black key from
the left (C#2) once, twice or three times on
one of the sixteen white keys (C1 to D3).
Afterwards, release the SET piston.
The quantity of presses corresponds to the
number of the analog input (#1 to #3) while
the white key defines the MIDI channel (1 to
16) on which you want the volume message
to be sent.
Each MIDI channel must be set separately in
this manner.
Sets the volume message on one MIDI channel. Any
channel can be set but only an active one will transmit
a message.
If you hit different white keys before releasing SET,
only the last one will be recognised and enabled
according to the quantity of presses you made. More
than three presses will be treated as three.
Note that the crescendo input does not require setup
because it produces messages for the Ahlborn Archive
modules.
8. DISABLING
VOLUME
MESSAGES
(CONTROLLER-7)
Hold the first piston from the left (SET) and
momentarily press the sixth black key from
the left (C#2). Afterwards, release the SET
piston.
Clears the volume settings for all active MIDI
channels on the keyboard. You cannot clear just one
but must clear all and start again as above. You can
change just one by using the configuration software.
9. SET A MIDI
CHANNEL TO
SEND EXPRESSION
MESSAGES
(CONTROLLER-11)
Hold the first piston from the left (SET) and
momentarily press the sixth black key from
the left (D#2) once, twice or three times on
one of the sixteen white keys (C1 to D3).
Afterwards, release the SET piston.
The quantity of presses corresponds to the
number of the analog input (#1 to #3) while
the white key defines the MIDI channel (1 to
16) on which you want the expression
message to be sent.
Each MIDI channel must be set separately in
this manner.
Sets the expression message on one MIDI channel.
Any channel can be set but only an active one will
transmit a message.
If you hit different white keys before releasing SET,
only the last one will be recognised and enabled
according to the quantity of presses you made. More
than three presses will be treated as three.
Note that the crescendo input does not require setup
because it produces messages for the Ahlborn Archive
modules.
10. DISABLING
EXPRESSION
MESSAGES
(CONTROLLER-11)
Hold the first piston from the left (SET) and
momentarily press the sixth black key from
the left (D#2). Afterwards, release the SET
piston.
Clears the expression settings for all active MIDI
channels on the keyboard. You cannot clear just one
but must clear all and start again as above. You can
change just one by using the configuration software.
11. SET
TRANSPOSE
VALUE
Hold the first piston from the left (SET) and
momentarily press any key EXCEPT the first
seven black keys. Then, release the SET
piston.
The next key pressed will send the note
number that Middle-C will become.
For example, if you want to transpose down two semi-
tones to B-flat, press B-flat (A#2). Transposition is not
cumulative.
If you need to set it where one of the first seven black
keys is, you will have to use the General Settings
window. See 6. Software Configuration.
NOTE :
All configuration changes made as above will be saved permanently (written to the EEPROM) after SET
is released. These settings will remain, even if the keyboard power is removed. All but the first can be set
using the configuration software for Windows or MacIntosh computers.
The SET piston in a multi-keyboard system must be the one on the keyboard you want to edit.