User manual

MIDI KEYBOARD CMK-2 SOFTWARE CONFIGURATION MANUAL v1.5
CMK-2 Manual 1.5.doc 2009 CLASSIC ORGAN WORKS 27
Software Startup
After installation, a shortcut (or alias) titled ‘CMKConfig’ will be created in the ‘Classic Organ Works’ folder (Start
menu→ Programs→ Classic Organ Works→ CMKConfig). To start using the software, double-click your left mouse
button on this ‘CMKConfig’ shortcut/alias. You should then see a screen as shown below:
Figure 18 Config software startup screen.
After a few moments, the main menu selection will appear:
Figure 19 Config software main menu.
The main menu allows you to select one of two sources for the configuration and presents you with a selection window
from which you choose a file in the normal manner:
1. Load Current Settings from the CMK: This mode reads from a file in the CMK-2 memory.
2. Open Previously Saved CMK Configuration: This mode reads from a file stored on your computer.
Both sources allow you to modify settings and eventually save either back to the MCU or to the computer under a new
filename. In the case of a multi-keyboard system, all the memories are read in ‘daisy-chained’ sequence as one file
and saved back to their respective sources. You can load configuration files created with older software versions and
save them back in the new format.
Note: If the MIDI connection is not present when you attempt to open the file in the CMK-2, the software will keep
retrying to connect. Even though you then connect it, it still may not run. If so, close the CMKConfig program and
restart it.