User manual

_________________________________________________________________________________________________________
CMK-1 Manual (Issue-1)
Page-67 October 20, 2004
Table 17: Registered Parameter Numbers
[12]
To set or change the value of a Registered Parameter:
1. Send two Control Change messages using Control Numbers 101 (65H) and 100 (64H) to select the desired Registered Parameter
Number, as per the following table.
2. To set the selected Registered Parameter to a specific value, send Control Change messages to the Data Entry MSB controller
(Control Number 6). If the selected Registered Parameter requires the LSB to be set, send another Control Change message to the
Data Entry LSB controller (Control Number 38).
3. To make a relative adjustment to the selected Registered Parameter's current value, use the Data Increment or Data Decrement
controllers (Control Numbers 96 and 97).
Parameter Number
Decimal Control 101 Value
(MSB)
Control 100 Value
(LSB)
Parameter
Function
Data Entry Value
0 00H = 0 00H = 0 Pitch Bend
Sensitivity
MSB = +/- semitones
LSB =+/--cents
1 00H = 0 01H = 1 Channel Fine
Tuning
(formerly Fine
Tuning - see
MMA RP-022)
Resolution 100/8192 cents
00H 00H = -100 cents
40H 00H = A440
7FH 7FH = +100 cents
2 00H = 0 02H = 2 Channel
Coarse Tuning
(formerly
Coarse Tuning
- see MMA
RP-022)
Only MSB used
Resolution 100 cents
00H = -6400 cents
40H = A440
7FH = +6300 cents
3 00H = 0 03H = 3 Tuning
Program
Change
Tuning Program Number
4 00H = 0 04H = 4 Tuning Bank
Select
Tuning Bank Number
5 00H = 0 05H = 5 Modulation
Depth Range
(see MMA
General MIDI
Level 2
Specification)
For GM2, defined in GM2 Specification.
For other systems, defined by
manufacturer