Instruction manual

z Repeat/intro/random mode
z Press the repeat/intro/random button (17) during playback, you can select the difference modes as followed:-
(1) repeat 1
(2) repeat all track (3) intro play (4) random (5) off mode
Play mode indicator on LCD display
Repeat single track
Repeat all tracks
all
Intro play mode Intro
Random mode Random
Off mode -----------------
z Repeat play
You can listen the desired tracks or all tracks repeatedly by this function.
z Intro play
You can listen the beginning (10 seconds) of each file by this function & save time to when searching the desire song
z Random play
You can listen to all the tracks in a random order by using this function
Tracks programming (by remote control)
Up to 10 tracks can be programmed for MP3 file and play in any order. Before use, be sure the system is at stop mode
before programming:-
1. Set in USB/SD mode & set at stop mode.
2. Press the “Program” button, “ Prog “ will appear on LCD display (13). Moreover, it will indicate program no. and
digits for track no. to be programmed.
3. Select a desired track by pressing Skip up
(15) or down buttons (5).
4. Press the “ Program ” button to store the trace into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press “ Play/Pause/Stop ” button (4) to play the
MP3 file in assigned order.
7. To cancel the programmed file, stop playback the unit and then press “Program” button on remote control until
“ Prog “ has disappear on LCD display (13).
Encoding of Phono into MP3 file
The system is able to encode the phono to MP3 format and recording at memory media with USB connecting port or
SD/MMC card.
A) Phono encoding
1) Insert the USB or SD media to the main unit refer the “Playback of MP3 song via USB storage media or memory
card section”.
2) Set the function button to “ Phono “ mode and then press the “
Rec “ button (7) directly.
3) The LCD display will show “ “ or “ “ & “ “ and flashing, and the system is starting the encoding
mode after few seconds,.
4) Start playback at phono for the track which you want to recorded.
5) After finish of recoding, press the “
Rec “ button (7) until the LCD stop flashing and return to “ phono “ mode.
Remark:-
- The recording speed is 1:1 and according to the actual playing time of the phono
- The system will create a folder and then store the encoded track in it.
- The recording format is set at – MP3
bit rate : 128 kbps, sampling rate : 44.1khz
- No song title will be recorded during encoding mode.
- If both media (USB/SD) inserted to the device, the device will on default record to USB media when encoding
from phono.
- Because this device has USB as default recording device at USB mode encode, please do not insert the USB
media during encoding to SD card, it causes the device does to not function properly.
B) track separation (by remote handset)
You can divide the music into tracks by pressing the “ “ (track separation) button once at the remote control
during encoding from phono to USB/SD, the system will generate a new track and continue the recording. The text
“ phono “ at LCD display will flash one time, it mean the device has created a new track successfully.
EN-3