User's Manual

5. Press “SRS” button to activate Surround Effect for unique audio
enjoyment.
, SRS and symbol are trademarks of SRS Labs, Inc.
NOTE:
You should then be able to move around freely from one room to another without
any interference. If interference does occur (interruptions in the signal), press
the "Auto Scan" button once to find a better reception channel.
A For better stereo reception, stay approximately seven meters away from
the transmitter when you press the "Auto Scan" button.
B If it is impossible to find a satisfactory frequency, change the setting on
your transmitter, then press the "Auto Scan" button on the headphones to
find the corresponding channel.
To both protect the transmitter and save power, the transmitter automatically
switches off after approximately one minute if the signal that it receives from the
audio source is too weak for proper reception. If however the signal returns to an
acceptable level, then the transmitter automatically switches back on.
CHARGING THE BATTERIES
1. Place the On/Off switch on the receiver headphones in the Off position.
2. To recharge the headphone batteries, place the headphones on the
transmitter, taking care to ensure that the charge contacts touch the
transmitter's charge prongs.
3. The charge process starts automatically and the green indicator light comes
on. Be sure to charge new batteries for 24 hours before using them for the
first time in the headphones.