User's Manual

TROUBLESHOOTING
NO SOUND
- Ensure that the mains adapter is pushed fully into the power outlet
and that its cable is properly connected to the DC IN 12V connector
on the transmitter.
- Ensure that the headphones On/Off switch is switched to the On.
- The headphones battery charge level may be too low. Recharge the
batteries or replace them with fully charged batteries.
- Ensure that your TV set, Hi-Fi system or audio component is switched
on and set to a channel that broadcasts an audio signal.
- Use the headphones volume control to increase the sound level.
- The connected audio/video equipment may not be in playback mode.
Start playback on by the equipment.
- Check the battery compartments if batteries are at right positions.
DISTORTION
- Ensure that the "Stereo" indicator is lit. If not, adjust the tuning control
(Auto Scan) on the headphones until it lights.
- Use the channel selector to change the transmitter's transmission
frequency. Then you will need to adjust the tuning control on the
headphones until the "Stereo" indicator comes on.
- The headphones battery charge level may be too low. Recharge the
batteries or replace them with fully charged batteries.
- Ensure that the volume knob setting is correct.
- The headphones may be too far away from the transmitter. Move
closer to it.
- The audio signal input level is too low. Increase the volume from the audio
source.