User's Manual

P.9
and then press the “AUTO-SCAN” button on the headphone again.
4. . Charging the Batteries
a) Move the ON/ OFF switch on the headphones to OFF.
b) Plug the charging cable on one end into the jack marked CHG at the back
of the wireless transmitter (as shown in the picture below). Plug the other
end of the charging cable into the jack marked CHG. on the headphones.
c) The charging process will start automatically and the power LED on the
transmitter will change from red to green.
Important:
1. Only use the included rechargeable AAA batteries. When the headphones are
not in use, ensure the power is switched to the OFF position to avoid damaging
the batteries.
2. Make sure the headphone is turned off when charging the batteries
3. To ensure a long service life, fully charge the rechargeable batteries before
using the headphone for the first time. The initial charge takes 24 hours to
complete.
5. Switching Off
a) For protection of the transmitter and power saving, the transmitter will cut
off automatically if there is no/weak operation input signal from audio