Installation Guide

Mod. SLK807
Lighting Instructions
Classy Caps Mfg. Inc.
Kingsville, Ontario, Canada
www.fencecaps.com
How Your Solar Powered Post Cap Works
• The solar panel converts sunlight energy into electricity during the day. The
photocell automatically turns the light on at night with the electricity stored
in the batteries. It requires no wiring, because it runs off the sunlight energy
to recharge the batteries so there is no cost to operate the solar fixture.
• The number of hours the light stays on depends on your geographical
location, weather conditions and seasonal sunlight availability.
• Easy do it yourself installation.
Includes:
1 – Solar Post Cap Light 1 – 3.2V Rechargeable Battery
4 – Base Adaptors 2 – Stainless Steel Mounting Screws & Covers
Post Cap Installation
1) The 3.5”x3.5” (4x4 nominal) base adaptor has been pre-assembled to the solar top for
you as shown – Fig. 1. Please take note of the LED assembly for base installation
of your size post. See Base Assembly below.
2) Install the included battery. Make sure polarity is correct – Fig. 2
3) Turn the auto-off switch to auto – Fig. 3.
4) Secure to post using the two mounting screws provided. Push the 2 screw covers
into place. – Fig. 4
5) Allow 3-5 days of sunlight to fully charge the battery.
Base Assembly (to accommodate your size post)
1) Carefully remove the 4 LED’s from the base using a small straight edge screwdriver -
pry upwards on the side tabs of the LED’s that are attached to the wire – Fig. 3
2) Twist the base adaptor counter clockwise to remove – Fig. 5. NOTE: Be careful when
feeding the LED wires through the base not to pull the wire out of battery compartment.
3) Feed the LED’s / wire through the base for your size post and twist base clockwise to
secure to solar top – Fig. 5
4) Snap the 4 LED’s back into place – clockwise direction – Fig. 5
5) Carefully push the LED wires into the wire slots as shown – Fig. 3
6) See Post Cap Installation above.
To Replace The Battery
(Battery replacement is approximately 2-3 years)
1) Carefully remove the 2 screw cover plugs from the base adaptor and remove mounting
screws to access the battery compartment – Fig. 4
2) Replace the battery with a new 3.2V rechargeable battery of equal capacity. Make sure
polarity is correct – Fig.1
3) Allow 3-5 days of sunlight to fully charge the battery.
Troubleshooting
If the light does not turn on at dusk after 24 hours of charging:
• Check the battery to make sure it is making secure contact with the terminal.
• Be sure the solar panel is in a relatively sunny location.
• Make sure the solar panel is not affected by other light.
Maintenance
Periodically clean light fixture with soft cloth and warm soapy water.
One Year Limited Warranty
This product is warranted to be free from defects in workmanship or materials at the time of
purchase for one year, (excluding batteries). Should a defect occur, please contact our customer
service line at 1-866-460-4604 for service. Should any evidence of defects in material or
workmanship appear within the warranty period after the date of purchase, Classy Caps Mfg.
Inc. will either repair or replace the product at its option. Classy Caps Mfg. Inc. is not responsible
for injury, property damage, or other consequential damages or damages to third parties arising
directly or indirectly from an actual or alleged defect in material or workmanship of the product.
FIG 1
3.5” x 3.5” base
(4x4 nominal)
4” x 4” base 5” x 5” base
5.5” x 5.5” base
(6x6 nominal)
FIG 2
FIG 4
FIG 5
FIG 3
Solar Top