Operation Manual

ENGLISH
14
TREBLE
TREBLE (LEVEL)
User has 5 seconds to use the encoder volume knob to adjust the desired Treble level range from -6 to +6.
TREBLE CFQ (FREQ)
User has 5 seconds to use the encoder volume knob to adjust the desired Treble center frequency to 10KHz, 12.5KHz,
15KHz, or 17.5KHz.
BALANCE
User has 5 seconds to use the encoder volume knob to adjust the Balance between the right and left speakers from
R12 (full right) to L12 (full left).“C00” represents an equal balance between the right and left speakers.
FADER
User has 5 seconds to use encoder volume knob to adjust the Fader between the front and rear speakers from R12
(full rear) to F12 (full front).“C00” represents an equal balance between the front and rear speakers.
TUNER OPERATION
19)BAND BUTTON (BAND)
Press BAND to change between FM bands and AM(MW) bands.
20&21)TUNING UP/DOWN BUTTON ( / )
MANUAL TUNING
Press the Up Tuning( ) or Down Tuning ( )button for more than 3 seconds to move the radio frequency number
up or down by one step.
AUTO SEEK TUNING
Press the Up Tuning ( )or Down Tuning ( )button for less than 3 seconds to move to next station automatically.
12~17)PRESET STATIONS BUTTONS
Six numbered preset buttons store and recall stations for each band.
11)AUTOMATICALLY STORE / PRESET SCAN (AS/PS)
Automatically select 6 strong stations and store them in the current band. Select a band (if needed). Press AS/PS button
for more than three seconds.The new stations replace stations already stored in that band.
PRESET SCAN
Scan stations stored in the current band. Select a band (if needed). Press AS/PS button for less than 3 seconds.The unit will
pause for ten seconds at each preset station. Press AS/PS button again to stop scanning when the desired station is reached.
STEREO
The unit will automatically pick up a stereo signal when available.When in stereo mode, the ST icon appears in the display.
When no stereo signal is available, the unit will automatically revert to mono operation, and no icon will be displayed.
RDS OPERATION
RDS FUNCTIONS
The unit is equipped with the following RDS function:
- AF Alternative Frequencies
- CT Clock Time
- EON Enchanced other Network
- PI Program identifications
- PS Program service name
- PTY Program Type
- REG Regional Change
- TA Traffic Announcement
- TP Traffic program
1.AF FUNCTION
By pressing AF button < 3 seconds to select AF ON/OFF.‘AF’ icon will light up on the LCD. Under AF “On” mode, if the
tuned in station signal is getting weak, the unit will automatically switches to a different frequency on the same network with
stronger signal.
Factory Default setting is “AF ON”
MCD 773 manual-EN-werkdoc.qxd 22-10-2007 08:53 Pagina 14