Operation Manual

GB
55
5. Insert the plug in a duly installed 230 V/50 Hz protective contact socket, switch
on the device and run the device with the guide comb upwards and at a con-
stant speed through your hair. The guide is held in a level position.
Cutting without Cutting Length Accessory
This is suitable for trimming the hair.
WARNING!
In order to prevent accidents push the blade protector (3) up to the shearing
blade.
For areas which are not accessible to the razor it is possible to use the scissors.
 IMPORTANT:
Do not use the device for more than 10 minutes. Allow the equipment to cool
down for 10 minutes, before using it again.
Cleaning
• Disconnect the machine from the mains.
• Clean the device after use with a dry cloth.
• The blades and accessories should be cleaned with the brush.
When the device is not in use
If the mill is not going to be used for a considerable time, please remove the batte-
ries in order to prevent battery acid from leaking out.
Battery Disposal
The device contains rechargeable nickel-cadmium batteries.
NiCd:
• Used batteries and accumulators (rechargeable batte-
ries) should not be disposed of in domestic waste.
• These can be returned to a collection point for old
batteries or special refuse. Contact your local authority
for further information.
05-HSM 2697 NE Neu 55 18.11.2005, 14:26:47 Uhr