Operation Manual

Radio Operation

1. Turn the TV/OFF/RADIO switch (located on the right-hand side of the television

set) to the RADIO position.

2. Pull out the telescopic aerial as far as it will go and turn it until you receive the

best possible reception.

3. Push the FM-VHF-LOW/HIGH/AM-UHF switch on the right-hand side of the

television set to the desired band range: AM = MW, FM = UKW.

4. Use the TUNING control located on the right-hand side of the television set to

tune in to the desired station.

NOTE: The reception may be impaired through poor reception locations or thick

building insulation, etc! Try to optimise reception by turning the aerial. If necessary,

move the television set to another position.

You can adjust the volume to your requirements with the VOLUME regulator on the

right-hand side of the television set.

Switching Off

• Turn the TV/OFF/RADIO switch located on the right-hand side of the television

set to the OFF position. The television set is now switched off.

• Remove the mains adapter from the socket or the car adapter from the cigarette

lighter.

Input/Output Sockets

On the back of the television set are located various input and output sockets:

ANT: For the connection of an external antenna. Requires a 3.5 mm jack adap-

ter.

PHONE: For the connection of headphones with a 3.5 mm jack plug. If the sound

can only be heard on one side of headphones, use a stereo-mono adap-

ter!

VIDEO: For the connection of the video signal (picture signal), e.g. from a video

recorder via a chinch connection (not included).

AUDIO: For the connection of the sound signal, for example from a video recorder

via a chinch connection (not included).

Cleaning

• Always switch the machine off before cleaning it (TV/OFF/RADIO switch in the

OFF position).

• Clean the outside of the housing with a slightly damp cloth (not wet!), without

any additional agents!

5....-05-TV 486 DK 16.10.2002 8:36 Uhr Seite 17