Owner`s manual

Page 18
Out A
System Sound
DUMP
ASSORTED
EFFECT
HI HAT
CYMBAL
PERCUSSION
TOM
RIM
SNARE
KICK
MIDI
BUTTON
OPT
NOTE P
NOTE #
OUT B
OUT A
DYN
THRES
TRIG INPUT
SYSTEM
This is where you position a channel in the stereo image at the outputs A1 and A2, like a pan-
pot on a mixer. You can pan each channel individually. The stereo image stretches from 1.00
(full left) via 1.50 (center) to 2.00 (full right). There are 25 steps to either side of the center
position. By turning all the way counter clockwise you may switch off a channel from the A
outputs, by selecting OFF. See the figure in the appendix section.
Values: OFF, 1.00 ~ 2.00.
Out B
System Sound
DUMP
ASSORTED
EFFECT
HI HAT
CYMBAL
PERCUSSION
TOM
RIM
SNARE
KICK
MIDI
BUTTON
OPT
NOTE P
NOTE #
OUT B
OUT A
DYN
THRES
TRIG INPUT
SYSTEM
This sets the positioning of the channels that have been assigned to the output pairs B3, B4, B5
and B6. If e.g. you would like to send one channel to an input on a mixer, set Out A of that
channel to OFF, raise the Level B parameter to anything above 0 and set the Out B parameter to
any integer. A value of 3.00 corresponds to output B3, a value of 3.50 makes the channel
present in both of the B3 and B4 outputs, a value of 4.00 is only the output B4 etc. See the
figure in the appendix section.
Values: OFF, 3.00 ~ 4.00 ~ 5.00 ~ 6.00.
Note #
System Sound
DUMP
ASSORTED
EFFECT
HI HAT
CYMBAL
PERCUSSION
TOM
RIM
SNARE
KICK
MIDI
BUTTON
OPT
NOTE P
NOTE #
OUT B
OUT A
DYN
THRES
TRIG INPUT
SYSTEM
This sets the MIDI note number that each channel is transmitting and responding to. MIDI
note number 60 (middle C) is equivalent to C3 in the ddrum4. If you press the
SHIFT button,
you will get a numerical read-out in the
DISPLAY instead of the ”musical” default one. The sharp
notes (F#, C# etc) are indicated by a dot in the
DISPLAY.
Values: C-2 ~ G8 or 0 ~ 127.
Reference: System