Owner`s manual

3. Getting started: Using a Rotor Speed switch pedal NORD ELECTRO 2 V3.0x
Page 14
• As a sustain pedal for Piano sounds and as a Rotor Speed switch for the Organ sounds (see Sustain
Pedal Configuration below)
S
ETTING UP THE SUSTAIN PEDAL POLARITY
Set up the pedal polarity as follows:
1. Press the S
HIFT
+ P
ROGRAM 7 (PED.POL) but-
tons. The D
ISPLAY
reads ‘CL’ or ‘OP’.
2. Change sustain pedal polarity between ‘OP’
(Open) (open when pressed) and ‘CL’ (Closed)
(closed when pressed) with the U
P/DOWN NAVI-
GATOR buttons.
3. Press any button (except for the S
HIFT, STORE
or U
P/DOWN buttons) to exit.
S
ETTING UP THE SUSTAIN PEDAL CONFIGURATION
1. Press the S
HIFT
+ P
ROGRAM 8 (CONFIG) but-
tons. The D
ISPLAY
reads ‘P.S’ (Pedal Sustain)
or ‘P.t’ (Pedal toggle).
1. Change sustain pedal functionality between
‘P.S’ (Sustain for both Piano and Organ sounds)
and ‘P.t’ (sustain for Piano sounds and Rotor
Speed switch for Organ sounds) with the U
P
/
D
OWN NAVIGATOR buttons.
2. Press any button (except for the S
HIFT
, S
TORE
or U
P/DOWN buttons) to exit.
Nord Electro 2 sends and receives Sustain Pedal mes-
sages as MIDI (CC# 64). Note! If you have selected ‘P.t’, Rotor Speed selection is sent from the
sustain pedal as MIDI CC#82 - not CC#64!
USING A ROTOR SPEED SWITCH PEDAL
A foot switch connected to the R
OTOR SPEED input can be used to switch between Slow and Fast rotor
speed for the Rotary Speaker effect (see page 31). Nord Electro 2 will also send and receive Rotor Speed
switch messages via MIDI (CC# 82).
Note: The Pedal Polarity setting that you made for the S
USTAIN PEDAL input (see above) also
affects the R
OTOR SPEED input.