User manual

NORD LEAD 2X V1.0x 5. Programming Velocity Sensitivity: Morphing
Page 27
M
MM
M
O
OO
OR
RR
RP
PP
PH
HH
HI
II
IN
NN
NG
GG
G
Morphing is a term used to describe a continuous “transfer” between two images, sounds or similar. As
described above, the Velocity/Morph function in Nord Lead 2X is normally controlled by velocity. But
you can route the function to the M
OD
W
HEEL
instead which allows you to continuously fade between
two sounds – morphing!
The only thing you have to do to activate morphing for a sound that’s already set up for velocity control
is to press the Mod Wheel destination button until Morph is the only lit indicator:
However, if you are setting up a Morph sound from scratch, we recommend the following procedure:
1. Press the M
OD
W
HEEL
D
ESTINATION
(S
HIFT
) button until only the M
ORPH
LED is lit.
2. Make sure the M
OD
W
HEEL
is all the way down.
3. Set up the Program (sound) as you want it.
4. Move the M
OD
W
HEEL
all the way up.
5. Press the V
ELOCITY
/M
ORPH
A
SSIGN
button and adjust the knobs so that the Program sounds the
way you want it at “the other end” of the Morph.
6. Press the V
ELOCITY
/M
ORPH
A
SSIGN
button again.
7. Play and move the M
OD
W
HEEL
to try out the effect.
You can also use an Expression pedal for Morphing, see page 19.
Please note that the Velocity function in the Filter section can be used even if Morphing is active, so
that a Program can be basically Velocity sensitive even though Morphing is activated.
Push this button...
...until only the
M
ORPH
LED
is lit.