User manual

NORD LEAD 2X V1.0x 10. MIDI: About the MIDI implementation
Page 75
2. Press the S
PECIAL
button repeatedly, until the left character in the Display reads ‘t’ (for “touch”).
3. Select a Slot for which you want to set the aftertouch function.
4. To assign a parameter for the aftertouch, press S
TORE
. The D
ISPLAY
will flash, showing one of the
abbreviations in the table below.
5. Use the U
P
/D
OWN
buttons to select one of the following control functions:
6. After you have made your choice, press S
TORE
again. You return to the ‘t’ display.
7. Use the U
P
/D
OWN
buttons to select a control amount value (‘oF’ or ‘1’ to ‘7’). This value (shown to
the right in the D
ISPLAY
) determines how much the assigned parameter should be affected by a
received maximum aftertouch value. If you don’t want the Slot to be affected by aftertouch messages,
select the amount value ‘oF’.
8. If needed, repeat steps 3 to 7 to set aftertouch assignment for the other Slots.
9. Press S
HIFT
to exit the Special menu and return to “play mode”.
P
PP
P
R
RR
RO
OO
OG
GG
GR
RR
RA
AA
AM
MM
M
C
C C
C
H
HH
HA
AA
AN
NN
NG
GG
GE
EE
E
The descriptions below are only true if transmission/reception of Program Change messages is activated,
see page 66.
• When you select a new Program for a Slot, a Bank Select (see below) and Program Change message is
transmitted via MIDI, on the Slot’s MIDI Channel.
• Likewise, if a Program Change message is received on a certain MIDI Channel, all Slots set to that
MIDI Channel will switch to a new Program.
Display shows: Aftertouch assigned to:
LFO 1 Amount.
LFO 2 Amount.
Filter Cutoff Frequency.
FM Amount.
Oscillator 2 Pitch.