User guide

29
A.LEDA WASH
CAUSE AND SOLUTION OF PROBLEMS
THE PROJECTOR WILL NOT SWITCH ON
PROBLEMS
ELECTRONICS NON-OPERATIONAL
DEFECTIVE PROJECTION
REDUCED LUMINOSITY
POSSIBLE CAUSES CHECKS AND REMEDIES
No mains supply.
LED exhausted or defective.
Signal transmission cable faulty or disconnected.
Incorrect addressing.
Fault in the electronic circuits.
Lenses or reflector broken
Dust or grease deposited.
Check the power supply voltage.
Call an authorised technician.
Replace the cables.
Check addresses (see instructions).
Call an authorised technician.
Call an authorised technician.
Clean (see instructions).
358
(
14.09")
2
53
(9.96")
423
(
16.65")
2
50
(9.84")
360
(
14.17")
381
(15.00")
155
(6.10")
2
20
(
8.66")
3
20
(
12.60")
2
53
(
9.96")
3
74
(
14.72")
2
45
(
9.65")
155
(6.10")
584
(22.99")
160
(6.30")
380
(14.96")
395
(15.55")
330
(12.99")
476
(18.74")
360
(14.17")
460
(18.11")
479
(18.86")
160
(6.30")
2
90
(
11.42")
TECHNICAL INFORMATION
Power supplies available
100-240V 50/60Hz
Input power
K20 - 750VA
K10 - 450VA
K
5 - 170VA
Max 1800VA (with 11 A.leda Wash K5 connected in parallel)
Total output
K5 - Max 2100 lumens
K10 - Max 5500 lumens
K20 - Max 10500 lumens
LED source
Osram Ostar RGBW - 15W - LED
Average LED life: 50.000 h
Motors
5 (k10 & k20), 2 (k5) stepper motors, operating with
microsteps, totally microprocessor controlled.
C
ooling
High efficiency die-cast aluminium
Forced ventilation
Inputs
DMX 512
Ethernet
Working position
Working in any position.
Moving Head
Movement by means of two stepper motors, controlled by
microprocessor.
Automatic repositioning of PAN and TILT after accidental
movement not controlled by control unit.
Angle:
- PAN = 540°
- TILT = 270°
IP20 protection rating
Protected against the entry of solid bodies larger than 12mm
(0.47”).
No protection against the entry of liquids.
CE Marking
Complies with the following European Directives
- 2006/95/EC (LVD)
- 2004/108/EC (EMC)
- 2011/65/EU (RoHS).
Weights
K5: 7.5 Kg (16.5 lbs)
K10: 14 Kg (30.8 lbs)
K20: 19.5 Kg (43 lbs)