Operator`s manual

Operator's Manual: Model CB-1400
B-2
Wiring Diagrams (continued)
FIGURE B2 - Burner Wiring Diagram
BLACK
ORANGE
PRIMARY
OIL
FF
T
CAPACITOR
BURNER
MOTOR
SWITCH
CENTRIFUGAL
140
WHITE
CONNECTOR (FACE)
140 WATTS NOZZLE HEATER
CAD CELL
YELLOW
YELLOW
FORMER
TRANS−
T
BLACK
BLACK
NOZZLE TEMP.SW.
RED
RED
SOLENOID
AIR
SOLENOID
OIL
PREHEATER THERMOSTAT
LIGHT
JUMPERS
WHITE
GREEN
BLUE
1
3
24
AMBER
LIGHT
11
65
7
9810
12
13
WHITE
GREEN
BLACK
METER
PROVING SWITCH 120° N.O.
HOUR
N.O.
SWITCH
AIR
WHITE BLUE
AIR
(OPTIONAL)
COMPRESSOR
BLOCK HEATER 400 WATTS
BLACK BLACK
RED
BLACK
WALL
THERMO−
STAT
NOTE: WHEN RELEASING OR INSTALLING WIRES ON THE
TERMINAL STRIP USE THE SMALL SCREWDRIVER SUPPLIED WITH THE BURNER TO RELEASE THE TERMINAL JAWS. TO LOCATE THE SCREWDRIVER, OPEN THE HINGED ACCESS
PLATE ON THE TOP OF THE BURNER. THE SCREWDRIVER
TO RELEASE OR INSTALL A WIRE, CAREFULLY PUSH THE
BLADE OF THE SCREWDRIVER INTO THE RELEASE SLOT
ON THE TERMINAL STRIP UNTIL YOU FEEL THE JAWS "SNAP"
WIDE OPEN. LEAVE THE BLADE IN THE RELEASE SLOT TO REMOVE OR INSTALL A WIRE. TO RELEASE THE JAWS,
CAREFULLY PULL THE BLADE OF THE SCREWDRIVER
I88249−B
IS CLIPPED TO THE INSIDE OF THE BURNER HOUSING ON THE RIGHT.
FROM THE RELEASE SLOT.
BLACK
BROWN
BROWN
BROWN