Operator`s manual

Operator's Manual: Model CB-1400

4-11

Installing the Metering Pump (continued)

Figure 4I - Proper Positioning of Metering Pump Head

Alternate Mounting: Horizontal Positioning

ATTENTION: If the metering pump is to be mounted horizontally or on a bracket as shown in

Figure 4I, the pump head must be rotated counterclockwise so that it is aligned in a horizontal position. The

gauge arrow on the pump head must point up, or the pump will not prime.

1. Refer to Figures 4H and 4I.

2. Remove the two pump mounting bolts. The coupling is keyed and does not have set screws.

3. Rotate the pump head 180 degrees to the horizontal position as shown in Figure 4I.

4. Re-install and tighten the two pump mounting bolts.

5. Use the appropriate type of bolts and washers (user-supplied) to securely mount the metering

pump to the mounting bracket, which is to be installed on the appropriate wall in your building at a

distance not more than four (4) feet from the tank.

GAUGE

INLET

INLETINLETGAUGE

INLET

RECOMMENDED SETUP

PUMP IS MOUNTED

LEFT ON WALL

ALTERNATE MOUNTING

TO THE WALL MAKING THE

BLEED VALVE IS NOW CLOSE

I88708

ROTATION

INLET

GAUGE

INLET

(NOT RECOMMENDED)

BLEEDING DIFFICULT

ROTATION

NON−STANDARD SETUP

PUMP HEAD HAS BEEN

ROTATED 90° CCW FOR

HORIZONTAL MOUNTING

(THE 1/4" STREET ELBOW AND

1/4" X 3" NIPPLE CHANGE PLACES

IN THE PLUMBING SEQUENCE)

INLETINLET